Sketching Sketch Chamfers

To create a sketch chamfer:

  1. In an open sketch, click Sketch Chamfer Tool_Sketch_Chamfer_Sketch.gif on the Sketch toolbar, or click Tools > Sketch Tools > Chamfer.
  2. In the PropertyManager, set the Chamfer Parameters as necessary.
  3. In the graphics area, select the two sketch entities to chamfer. To select the sketch entities, you can:
    • Hold Ctrl and select two sketch entities.
    • Select a vertex.
    The chamfer is applied immediately.
  4. Click PM_OK.gif to accept the chamfer, or click Undo to remove the chamfer. You can undo a sequence of chamfers in reverse order.