Specifying Find Parameters for Legacy Holes

The Find: Hole Parameters dialog box lets you specify Find parameters for holes created with the Hole Wizard feature.

  1. Click the Legacy tab.
    Legacy holes were created by the Hole Wizard in versions earlier than SOLIDWORKS 2000.
  2. In the dialog box:
    1. Select a type of hole in Hole Type.
      SOLIDWORKS displays a schematic for the hole type.
    2. Select an item in End Condition.
    3. Edit the required dimensions in Section Dimensions. Some dimensions might not be available depending on the end condition type.
      Toggle greater_than.gif to change the comparison symbols >, <, and =.
  3. Click OK to accept the Find parameters and close the dialog box.