Changing Draft Using DraftXpert

To change draft using the DraftXpert Change tab:

In this example, you have already applied 3deg draft to the four orange-colored faces (two faces on each side of the horizontal cylinder).



  1. In the DraftXpert PropertyManager, select the Change tab.
  2. Under Drafts to Change, select the draft items to modify for Faces to Draft . In this example, you select the two orange-colored outer faces (one each on opposite sides of the horizontal cylinder).
  3. Set a value for Draft Angle and click Change to modify the draft for the selected faces. In this example, change the draft to 10deg.
  4. Under Draft Analysis, select Auto paint to see what other faces need draft.
    To remove draft from faces, you would click Remove.
  5. Click PM_OK.gif.