Sketching Sketch Fillets

To create a fillet in a sketch:

In an open sketch, click Sketch Fillet on the Sketch toolbar, or Tools > Sketch Tools > Fillet.
Set the properties in the Sketch Fillet PropertyManager.

Select the sketch entities to fillet.

You can select non-intersecting entities. The entities are extended at a virtual intersection, and the corner is filleted.

To select the sketch entities, you can select two sketch entities or select a corner.


When you select a sketch entity, then hover over another sketch entity, a preview appears.	When you select the second sketch entity, the preview changes colors.

When you hover over a corner, a preview appears.	When you select the corner, the preview changes colors.