Specifying Modify Parameters for Simple Holes
The Modify: Simple Hole Parameters dialog box lets you specify new parameters for cylindrical or conical holes created as Simple Hole features. The following parameters are available:
| Depth | Set a new value to change the hole depth. | |
| Diameter | Set a new value to change the hole diameter. | |
| Modify Draft | Select to remove drafts from the hole. Make sure Apply Draft is cleared. | |
| Apply Draft | Select to change the hole's draft angle. Make sure Modify Draft is selected. To change the hole's draft angle, set a new Angle, and select either Only Inward or Only Outward to change the draft slope. | |
| Reverse Offset | Select Any, On, or Off. (For Offset From Surface as End Condition only.) | |
| Translate Surface | Select Any, On, or Off. (For Offset From Surface as End Condition only.) |
You cannot change the End Condition during Modify.