Specifying Modify Parameters for Hole Wizard
The Modify: Hole Parameters dialog box lets you specify new parameters for holes created using the hole wizard and for legacy holes. The dialog box that appears depends on the type of hole that you selected during Find. In each dialog box, there is a table of parameters that you can edit.
If you chose different-sized holes, the table does not show any entries. If you chose holes of the same size, the dimensions are shown in the table.
- For Counterbore holes, you can change the Depth, Hole Diameter, Angle at Bottom, and C'Bore Diameter & Depth.
- For Countersink holes, you can change the Depth, Hole Diameter, Angle at Bottom, and C'Sink Diameter & Angle.
- For Holes, you can change the Depth, Hole Diameter, and Angle at Bottom. If you chose countersink holes, you can change only these three parameters. To change the dimensions of the countersink, you should specify Countersink during Find.
- For Tap holes and PipeTap holes, you can change the Depth, Tap Drill Diameter & Angle, and Thread Depth.
- For Legacy holes, you can change the parameters that are appropriate to the type of hole you specify during Find. You cannot change the type of hole.
- For All Wizard Holes, you can change the Hole Diameter and Hole Depth.
Type new values, then click OK to close the dialog box.
You cannot change the type or end condition of the hole during
Modify.