Specifying Find Parameters for Simple Holes
The Find: Simple Hole Parameters dialog box lets you specify Find parameters for a simple hole. The following parameters are available:
You cannot find simple holes made with the Hole Wizard in this dialog box. You must use the Find: Hole Parameters dialog box.
| End Condition | Select an extrusion type. | |
| Diameter | Set a value for the hole diameter. Toggle
|
|
| With Draft | To select by draft angle, select With Draft and set a value for Angle. You can also select a draft
type: Only Inward, Only Outward, or Any. Toggle
|
|
| Reverse Offset | Select Any, On, or Off. (For Offset From Surface as End Condition only.) | |
| Translate Surface | Select Any, On, or Off. (For Offset From Surface as End Condition only.) |