Useful Links

Specifying Find Parameters for Boss or Cut Extrudes

The Find: Boss Extrude Parameters and Find: Cut Extrude Parameters dialog boxes let you specify Find parameters for extrusions. The following parameters are available:

Direction1

Start Condition

Select a start condition to find. If Offset, set an Offset value.

End Condition

Select an end condition to find.

Depth

Set a value for the depth of the extrude feature.

Toggle to change the comparison symbols >, <, and =.

With Draft

Select to find extrusions by their draft angle. Set an Angle to find extruded features with drafts at a specified angle.

Toggle to change the comparison symbols, if necessary.

Merge Result (Boss extrudes only)

Select Any, On, or Off.

Flip Side to Cut (Cut extrudes only)

Select Any, On, or Off

Reverse Offset and Translate Surface (For Offset From Surface as End Condition only)

Select Any, On, or Off

Direction2

Select Any, On, or Off. If you select On, set the options similar to Direction1.

Thin Feature

Select to find thin feature extrusions.

Type	Select an option.
Thickness	Set a value for T1 and T2 (Two-Direction only).

For extrudes created in both directions, only one direction must satisfy the Find criteria to find the feature. For example, a boss extrude has a depth of 5mm in the first direction and 2mm in the second direction. If you Find all extrudes < 3mm, the boss extrude is found because the second direction is less than 3mm.