Stamp PropertyManager
To open this PropertyManager:
- In a sheet metal part, click Stamp (Sheet metal toolbar) or .
Stamp Parameters
| Depth | Specifies the stamp depth from the top or bottom of the sheet metal face. | |
| Reverse Direction | Reverses the direction of the stamp. | |
| Draft Angle | Specifies the taper angle to apply to the stamp side faces. |
Fillet
If you specify a radius in the sketch before creating a stamp, the
sketch radius is prioritized when creating the stamp.
|
|
| 1 | Die Radius (R1) | Specifies the radius created by the die. | |
| 2 | Punch Radius (R2) | Specifies the radius created by the punch. | |
| 3 | Punch Side Corner Radius | Adds a corner punch radius. Specify the Radius
|