Angle Mate
You can add an angle mate between the combinations shown below.
Enter an angle value in the Angle box in the Mate PropertyManager. The default value is the current angle between the selected entities.
You can apply different angle mate dimensions to different configurations. Click the down arrow next to Angle and select one of the following options:| This Configuration | Applies the value to the active configuration only. | |
| All Configuration | Applies the value to all configurations in the model. | |
| Specify Configuration | Applies the value to the active configuration and any selected configurations. |
| Cone | Cylinder | Extrusion | Line | Plane | |
|---|---|---|---|---|---|
| Cone | |||||
| Cylinder | |||||
|
Cylinder refers to the cylinder's
axis.
|
|||||
| Extrusion | |||||
|
Extrusion refers to a single face of an
extruded solid or surface feature. Extrusions with draft are
not allowed.
|
|||||
| Line | |||||
| Plane | |||||