Fit Spline PropertyManager

To open the Fit Spline PropertyManager:

1. In an open sketch, click Fit Spline (Spline Tools toolbar) or Tools > Spline Tools > Fit Spline.
2. In the graphics area, click the sketch entities to fit to the spline.

Parameters

Delete geometry	Deletes the original sketch segments from the sketch. Otherwise, the segments remain as construction geometry separate from the spline. When cleared, you can select the Constrained, Unconstrained, or Fixed options.
Closed spline	Creates a closed contour spline.
Constrained	Parametrically links the fitted spline to the defining geometry.
Unconstrained	Creates the fitted spline as the same shape as the original defining geometry but with no constraints. You can dimension, constrain, and drag the spline.
Fixed	Creates the fitted spline as the same shape as defining geometry but it is fixed in space.
Undo Spline	Restores a spline to its previous state by canceling the last operation. Undo Spline is available only when you have multiple splines, click to pin down the PropertyManager, change one spline, and then click .
Edit Chaining	Allows you to edit the chain of splines created. Editing applies only to the order of the non-contiguous spline elements, not the sketch entities. Click or to undo or redo the edits.

Tolerance

	Tolerance	Specifies the maximum deviation allowed from the original sketch segments. Use the thumbwheel to adjust the tolerance so you can see changes to the geometry in the graphics area.
	Actual Deviation	Updates based on the Tolerance value and the geometry selected. This is automatically calculated.

Preview Options