Line Properties PropertyManager - 3D

Controls the following properties of a sketched 3D Line.

To open the Line Properties PropertyManager:

In a 3D sketch, select a line.

Existing Relations

Relations Displays relations inferenced automatically during sketching or created manually with Add Relations. When you select a relation in the list, a callout is highlighted in the graphics area.
Information Displays the status of the selected sketch entity (Fully Defined, Under Defined, and so on).

Add Relations

You can add relations to the selected entity. The list includes only relations that are possible for the selected entity.

Options

For construction Converts the entity to construction geometry.
Infinite length Creates a line of infinite length that you can later trim.

Parameters

Length

Additional Parameters

You can specify any appropriate combination of the following parameters to define the line if the line is not constrained by relations. When you change one or more parameters, the other parameters update automatically.

Start X Coordinate  
Start Y Coordinate  
line_start_z.png Start Z Coordinate  
End X Coordinate  
End Y Coordinate  
End Z Coordinate  
Delta X Difference between the start and end X coordinates.
Delta Y Difference between the start and end Y coordinates.
Delta Z Difference between the start and end Z coordinates.