Circle PropertyManager
Controls the properties of a perimeter-based or center-based sketched circle.
To open the Circle PropertyManager:
In an open sketch, select a circle.
Existing Relations
| Relations | Displays relations inferenced automatically during sketching or created manually with Add Relations. When you select a relation in the list, a callout is highlighted in the graphics area. | |
| Information | Displays the status of the selected sketch entity (Fully Defined, Under Defined, and so on). |
Add Relations
You can add relations to the selected entity. The list includes only relations that are possible for the selected entity.
Options
| For construction | Converts the entity to construction geometry. |
Parameters
You can specify any appropriate combination of the following parameters to define the circle if the circle is not constrained by relations.
With Center creation selected, set values for:
| Center X Coordinate | |
| Center Y Coordinate | |
| Radius |