Weldment Cut List PropertyManager

To open the Weldment Cut List PropertyManager:

1. In a drawing, click Weldment Cut List (Table toolbar) or Insert > Tables > Weldment Cut List.
2. Select a drawing view.

Table Template

Click Browse for template to choose a standard or custom template. This option is available only during table insertion. The weldment cut list table templates supplied with the software add columns to the default format. They are located at: install_dir \lang\english. The standard template (cut list.sldwldtbt) creates ITEM NO., QTY., DESCRIPTION, and LENGTH columns.

Table Position

The stationary corner controls the direction in which the table expands when adding new columns or rows.

Set the Stationary corner to:

	Top Left	New columns extend to the right and new rows extend below the anchor point.
	Top Right	New columns extend to the left and new rows extend below the anchor point.
	Bottom Left	New columns extend to the right and new rows extend above the anchor point.
	Bottom Right	New columns extend to the left and new rows extend above the anchor point.

Configurations

Cut lists are usually based on the As Welded configuration.

Keep Missing Item

If cut list items have been deleted from the weldment since the cut list was created, you can keep the items listed in the table. If missing items are kept, select Strikeout to display text for the missing item with strikeout formatting.

Item Numbers

	Start	The cut list starts with the number displayed.
	Do not change item numbers	Click for item numbers to remain with their rows when columns are sorted or re-ordered.

Border

	Box Border	Sets a line thickness for the outside border of the table.
	Grid Border	Sets a line thickness for the inner grid lines of the table.

Layer

In drawings with named layers, select a layer. The table assumes the layer color.

Text Format