Holes The sequence of diagnosis error messages for holes is as follows. Contents Hole - Planar Face A planar face cannot be a hole. Hole - Spline Face The spline face is not axisymmetric. Hole - Unknown Volume Type The face does not represent a valid hole size. Hole - Mixed Volume There is a protrusion and a depression in the hole. Hole - Protrusion Other geometry is protruding into the hole. Hole - Large Diameter The diameter of the hole is too large to recognize. Hole - Multiple Multiple hole recognition is not supported. Hole - Partial Hole - Invalid Selection The selection is not valid for hole recognition. Hole - General Failure The face does not represent a valid hole. Parent topicDiagnostic Error Messages Chamfers Boss and Cut Extrudes Fillets Revolves General Errors